1.The diamond cutting wire of cutting mountai

In Iran, the use of the diamond cutting wire of mountain has been in common from 1991.

Before that year, there has been used from the explosion method in order to extract, the stone from mines. There has been put a lot of injuries and loss on the stone mass in addition to loss which has been minimized.

In this corporation. the diamond segment appropriate to genous and hardness degree of stone on the basis of the mouse table is designed and produced in order to facilitate the work and obtain the most efficiency and cutting wire output.

In this regard, all the stone sample types around Iran has been collected and has been performed for cutting wire of the diamond cutting wire.

(The photos of Iran stone samples)

The diamond cutting wire kind of cutting mountain is below:

1.1 Electroplate (the soft cutter)

In this method. a diamond layer has been plating on the segment basis.This segment property is the high cutting speed of that (10 – 14 square meter / hour). there has been used from that in order to cut the Gohare, travertine, and Crystalline marble.

1-2 sintering (hard cutter):

 This most new method is the diamond cutting wire production in the world. Which its technology is under the authority many corporations (diamond stone corporation of Zagross- Italy diamond etc..)

In this method, many homogenous layers of diamond are placed in the amalgamation of cobalt and Bronze then are pressed and passed from furnace, this operation is called sintering. The pressing processes and segment montage are observed.

The cold montage and press montage.

     The more age of this is the property of this segment.

          1.    Turbo: to cut the marble stones and decorative Travertine.

          2.    Silver: To cut the travertine stones.

          3.    Crystalline: To cut the Crystalline marble , Gohare , limestone.

          4.    Soft cutter: To cut the Crystalline marble ,Gohare, Travertine.

technical specificat: